Find Us On Google+

Manuals

Karaoke – Jukebox  Fairy floss  Hot Dog  Popcorn  Slushie


Karaoke – Jukebox  MACHINE

Instructions for use: 
If you have a computer expert that knows everything about computers
KEEP HIM/HER AWAY FROM THIS UNIT an (expert ) will do more harm than good…
Read these instructions before attempting to fix anything…

THIS IS A TOUCH SCREEN ONLY ONE FINGER TIP TO USE ON SCREEN IF YOUR PALM OR SLEEVE IS TOUCHING THE SCREEN IT WILL NOT WORK WITH YOUR FINGER TIP….

Turn all Volume controls to the left (off position) before plugging in power.

POWER CORD – LOCATED IN back of machine (white lead )

1.Plug the power cord in.

2.Turn unit on at the left hand side there is a small hole push the small button  a green light with be visible.

3. Wait for 10 – 15  minutes for machine to load up all the songs.

4. DO NOT TOUCH THE SCREEN FOR 15 MINUTES WHILE TRACKS ARE UPDATING.

5.ONCE THE TRACKS HAVE LOADED YOU WILL SEE SONGS ON THE LEFT HAND SECTION.

6.On the top there is several icons Setting icon – Fast Forward / Play – Pause

and the search Magnifying Glass.

7. Touch the Magnifying glass and it will bring up a search screen type in any song or artist and touch the enter arrow,

This will bring up all the tracks relevant to your search selection,

On the right you can move the slide bar down or up for more tracks relevant to your search selection.

Once you have found the song you like touch it and it will change colour to (Blue) now touch the enter button on the right this will load it into the play section on another screen

To add more tracks touch another song and touch enter again this will queue up the tracks.

On the search screen touch the x to exit this screen.

8.If a Karaoke track has been loaded it will automatically bring up the Karaoke screen with words on it there may be a 6 second delay in the karaoke tracks this is normal.

9. There is a slide bar in the middle of the screen at the bottom this can be used to go forward or reverse on any track.

10. There is lights that work on sound the lead for these is the top plug in the power board at the back of the unit you can unplug these is not required.

11. adjusting the volume,

On the mixer unit there is 9 volume control knob’s turn them all to the left this will turn them all off.

From the left the first one will be the master volume turn this one to 5

The next two adjust to 3 or 4 if the green light over the volume control knob for 1 and 2 is on turn down the 1 and 2 volume.

Channel 3 and 4 are for the microphones adjust to required volume (there is an off/on switch on the microphones) if the green light over the volume control knob for 3 and 4 is on turn down the 3 and 4 volume

Channel 5 and 6 are empty

Channel 7 and 8 are for the input jack   I pod headphone output.

To turn unit off unplug from wall that’s it. do not shut down windows normally.


FAIRY FLOSS MACHINE

Instructions for use:

1.Plug the power cord in.

2. Put 1/2 cup of Fairy floss mix in the The circular hole / cylinder in the middle of the tub

3. Turn the POWER ON at the front right hand side of the machine

4. The Machine will spin nothing will happen until the heat is correct then it will produce floss.

5. Use serving stick and move clockwise with the floss and whilst in your hand turn the stick anticlockwise , one scoop will make one stick.

6. To make more floss add another 1/2 cup of floss mix no need to turn the machine off to add mix but keep hands off the spinning hot head..

7. When enough has been made Turn on the auto cooling button and it will cool down and turn off on its own.

8.Turn power off at wall and unplug when finished.

Equipment provided:

Fairy floss machine – power cord – sugar scoop – tub of floss mix – serving sticks.

Cleaning – unplug power from wall – wait till machine has cooled down remove top stainless steel bowl and clear bubble cover.

– wash with hot soapy water – towel dry

no need to put back together.


HOT DOG MACHINE

Instructions for use:

1. LIFT THE LID AND REMOVE THE WIRE RACK

2. FILL COMPARTMENT WITH WATER JUST ENOUGH WATER TO COVER THE ELEMENT

3. REPLACE THE WIRE RACK AND LID.

4. Plug the power cord in.

5. TURN THE RIGHT HEAT CONTROL KNOB MARKED (T) TO HI.

(this will bring the water to boil in a short time)

6. REDUCE THE HEAT CONTROL (T) DOWN TO NUMBER 2 OR 3 SO IT WILL SIMMER

7. PLACE HOT DOGS IN BASKET.

8. THE HEATING COMPARTMENT IS DIVIDED INTO TWO COMPARTMENTS ALLOWING HOT DOGS TO BE USED FROM ONE COMPARTMENT WHILST HOT DOGS ARE BEING HEATED IN THE OTHER.

9. DO NOT HAVE THE WATER TO HOT OR THE HOT DOGS WILL BURST..

10. CHECK WATER LEVEL FROM TIME TO TIME AND TOP UP AS NECESSARY.

11. TURN THE HEAT CONTROL KNOB ON THE LEFT HAND SIDE MARKED (S) TO HI

THIS WILL HEAT THE SPIKES

12. PUSH THE ROLLS OVER THE SPIKE AND WAIT UNTIL WARM

13. SLIDE ROLL OFF AND PUT HOT DOG INSIDE ROLL

14. TURN DOWN THE HEAT CONTROL KNOB ON THE LEFT HAND SIDE MARKED (S)

WHEN NOT USED.

15. Turn power off at wall and unplug when finished.

Cleaning – unplug power from wall – wait till machine has cooled down remove top stainless steel LID – BASKET – GLASS CASE –  EMPTY WATER OUT

– wash with hot soapy water – towel dry


POPCORN MACHINE

Instructions for use:

1.Plug the power cord in.

2.Turn the switches ‘Warm light’ and ‘Heat’ ON.

3.Lift lid that sits on the pot as high as it will go there is a     magnet on the roof it will stick to.

4.Squirt a little OIL into the pot.

5.Add one cup of corn.

6.Add 1/2 to 1 Teaspoon of Butter salt to the pot.  (Caution POT will get very HOT)

7.when the corn has popped they will overflow into the popcorn warmer at the bottom.

8. the pot can now be emptied by the lever inside that machine.

To make more repeat from step  4  – 8

If no more corn is to be made turn off the switch marked HEAT

Popcorn will remain warn with Warm Light still on

Turn power off at wall and unplug when finished.

Equipment provided:

popcorn warmer – scoop – large tub of corn – container of OIL –  small tub of salt

Cleaning – unplug power from wall – wait till machine has cooled down empty corn tray at bottom – wash with hot soapy water – towel dry


Slushie MACHINE

Instructions for use:

Take out from the machine the drip trays (light leads if in the machine) and water jug

The machine should be empty and only have the white auger in it..

Make sure the plastic clear bowls are in there correct place, there is a notch in the front of the bowl that sits in behind the front panel, if this is not in correctly the unit will leak everything out of the bowls quickly..

1.Plug the power cord in the machine should start automatically  on most of our machines if not turn all controls to ON  at the control panel on the right hand side of the machine.

All GBG machine controls are to be pushed up.

2. THE MIX RATIO IS VERY IMPORTANT 1 LTR OF SYRUP TO 4 LTRS OF WATER

IF ALCOHOL IS TO BE ADDED USE LESS WATER

1 LITRE  SYRUP +  3.5 LITRES  WATER  AND 500ML ALCOHOL TOTAL IS 5 LITRES

2 LITRE  SYRUP + 7 LITRES  WATER  AND 1 LITRE  ALCOHOL TOTAL IS 10 LITRES

3. put the Drip Trays in front of the machine there is hangers for them.

4. start with adding the water that is required, if there is any leaks it will only be water spilling out and not syrup..   then add syrup and alcohol if required.

fill machine to 10 litres  in most cases this will be 50% of syrup ordered and straight forward for customers to work out the mix ratio during the event

5. place lids on and plug in the light leads on the back of the machine on the curved section behind the bowl at the top.

6. Freezing time will depend on the ambient temperature between 30 min to 45 min  is normal.

7. Refilling the machine, Remove the lids, follow step no 2 , and  step no 5

8. Turn power off at wall and unplug when finished.

9. Cleaning the machine – unplug power from wall  – empty out all the mix rinse with water empty and drip trays. towel dry.

no need to put back together.